Additional Safety Rules - Makita HR4001C Manual De Instrucciones

ENGLISH
1 Switch trigger
2 Switch lever
3 Adjusting dial
4 Change lever
5 Pointer
6 Lock button
7 Power-ON indicator lamp
(green)
8 Service indicator lamp (red)
9 Side handle
SPECIFICATIONS
Capacities
No load speed (min
Blows per minute
Overall length
Net weight
Safety class
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Intendended use
The tool is intended for hammer drilling in brick, concrete
and stone as well as for chiselling work.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Safety hints
For your own safety, please refer to the enclosed safety
instructions.

ADDITIONAL SAFETY RULES

1. Wear ear protectors. Exposure to noise can cause
hearing loss.
2. Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
3. Hold tools by insulated gripping surfaces when
performing an operation where the cutting tool
may contact hidden wiring or its own cord. Con-
tact with a "live" wire will make exposed metal parts
of the tool "live" and shock the operator.
4. Wear a hard hat (safety helmet), safety glasses
and/or face shield. It is also highly recom-
mended that you wear a dust mask and thickly
padded gloves.
5. Be sure the bit is secured in place before opera-
tion.
Explanation of general view
10 Clamp nut
11 Side grip
12 Bit shank
13 Bit grease
14 Bit
15 Chuck cover
16 Depth gauge
17 Clamp screw
18 Blow-out bulb
19 Screws
Model
Carbide-tipped bit
Core bit
–1
)
HR4001C
5.9 kg
6. Under normal operation, the tool is designed to
produce vibration. The screws can come loose
easily, causing a breakdown or accident. Check
tightness of screws carefully before operation.
7. In cold weather or when the tool has not been
used for a long time, let the tool warm up for a
while by operating it under no load. This will
loosen up the lubrication. Without proper warm-
up, hammering operation is difficult.
8. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
9. Hold the tool firmly with both hands.
10. Keep hands away from moving parts.
11. Do not leave the tool running. Operate the tool
only when hand-held.
12. Do not point the tool at any one in the area when
operating. The bit could fly out and injure some-
one seriously.
13. Do not touch the bit or parts close to the bit
immediately after operation; they may be
ENB010-2
extremely hot and could burn your skin.
SAVE THESE INSTRUCTIONS.
20 Connector
21 Black
22 White
23 Screw
24 Crank cap cover
25 Control plate
26 Screwdriver
27 Crank cap
28 Hammer grease
HR4010C HR4011C
40 mm
105 mm
235 – 480
1,350 – 2,750
468 mm
6.3 kg
/II
6.3 kg
7