Additional Safety Rules - Makita HR5000 Manual De Instrucciones

ENGLISH
1 Clamp nut
2 Side handle
3 Side grip
4 Tool holder
5 Tool retainer
6 Change lever
7 For rotation with hammering
SPECIFICATIONS
Model
Capacities
Tungsten-carbide bit ........................................................................................ 50 mm
Core bit
Concrete ........................................................................................................ 150 mm
Hume pipe ..................................................................................................... 255 mm
–1
No load speed (min ) ........................................................................................ 260
Blows per minute ................................................................................................ 2,100
Overall length ...................................................................................................... 476 mm
Net weight ........................................................................................................... 9.6 kg
• Due to our continuing program of research and
development, the specifications herein are subject
to change without notice.
• Note: Specifications may differ from country to
country.
Power supply
The tool should be connected only to a power supply
of the same voltage as indicated on the nameplate,
and can be operated on single-phase AC/DC supply.
They are double-insulated in accordance with Euro-
pean Standard and can, therefore, also be used from
sockets without earth wire.
Safety hints
For your own safety, please refer to the enclosed
Safety instructions.

ADDITIONAL SAFETY RULES

1. Wear a hard hat (safety helmet), safety glasses
and/or face shield. It is also highly recom-
mended that you wear a dust mask, ear pro-
tectors and thickly padded gloves.
2. Be sure the bit is secured in place before
operation.
3. Under normal operation, the tool is designed
to produce vibration. The screws can come
loose easily, causing a breakdown or accident.
Check tightness of screws carefully before
operation.
4. In cold weather or when the tool has not been
used for a long time, let the tool warm up for
several minutes by operating it under no load.
This will loosen up the lubrication. Without
proper warm-up, hammering operation is dif-
ficult.
Explanation of general view
8 For hammering only
9 Switch trigger
10 Core bit
11 Adapter
12 Center bit
13 Rod
14 Hex wrench
5. Always be sure you have a firm footing.
6. Hold the tool firmly with both hands.
7. Keep hands away from moving parts.
8. Do not leave the tool running. Operate the tool
9. Do not point the tool at any one in the area
10. When drilling or chipping into walls, floors or
11. Do not touch the bit or parts close to the bit
SAVE THESE INSTRUCTIONS.
OPERATING INSTRUCTIONS
Side handle (Fig. 1)
The side handle swings around 360° on the vertical
as well as back and forth on the horizontal. Turn the
clamp nut clockwise to secure the handle in the
desired position.
Side grip (Fig. 2)
The side grip is convenient for downward drilling or
chipping operations. Screw the side grip on the tool
securely. The side grip can be installed on either side
of the tool for right or left hand operation.
15 Rear cover
16 Screwdriver
17 Brush holder cap
18 Lock nut wrench
19 Crank cap
20 Hammer grease
HR5000
Be sure no one is below when using the tool in
high locations.
only when hand-held.
when operating. The bit could fly out and
injure someone seriously.
wherever "live" electrical wires may be
encountered, DO NOT TOUCH ANY METAL
PARTS OF THE TOOL!
Hold the tool by the insulated grasping sur-
faces to prevent electric shock if you drill or
chip into a "live" wire.
immediately after operation; they may be
extremely hot and could burn your skin.
HR5000K
50 mm
150 mm
255 mm
260
2,100
503 mm
9.7 kg
5