Memory Functions; Auto Switch Off - ALLURIS SMT-200C Instrucciones De Servicio

Tighten the shaft screw with an appropriate tool when using the 12"
measuring wheel.
The instrument is switched on by pressing the measuring button.
Select the engineering unit. – Make sure that the engineering unit
and align the instrument with the tip straight and
exactly in the centre (turning axis) of the machine
element.

6.0 Memory Functions

The memory can be cleared by keeping the MEM button pressed for
approx. 6 sec (the display indicates CCCCC). It is automatically erased 5
minutes after the last measurement or when the batteries are replaced.

7.0 Auto Switch Off

To save battery the instrument switches off automatically after a certain
period of time.
matches with the operation mode (contact, non-
contact) and the measuring attachment.
Attach the appropriate accessory for your application.
Optimal distance for non-contact measurement is
approx. 50 cm (1 ½ ft) at a 10-30°
angle.
For contact measurements insert
For speed and length measurement
use the measuring wheel and keep
the instrument in right (90°) angle to the moving
direction of the material.
Avoid any movement of the instrument itself while
measuring, which has a direct impact on the result and
reproducibility of your measurement.
The maximum (highest inflection point), the
minimum (lowest inflection point) and the
last measured value are saved automatically
in the memory. Further values can be
captured by pressing the MEM button during
the
calculate and indicate the average (AV) of
these free captured measurement values.
To recall stored data, press MEM button after
releasing the measuring button.
measurement. Certain models can