Starting Up The Device - Weller HAP 200 Manual De Uso

HAP 200
WARNING!
4.1 Technical data HAP 200
Heating output
Heating voltage
Max. air flow rate
Temperature range
Temperature accuracy
Potential balance
The HAP 200 Hot Air Tool has an equipotential bonding conductor
which can be connected in accordance with the operating
instructions of the control unit in use.

5 Starting up the device

Risk of injury due to hot air and inert gases.
Use caution when operating the Hot Air Tool, because hot air can
cause burns. Caution: use of inert gases in an enclosed area can
cause asphyxiation.
Please read carefully the safety instructions in the attached
booklet, the safety guidelines given in these operating
instructions and the operating instructions of your control unit
before putting the HAP 200 into operation. Also observe the
safety precautions described herein.
1. Carefully unpack Hot Air Tool HAP 200.
2. Make sure that the control unit is OFF.
3. Place the HAP 200 Hot Air Tool into the stand (4).
4. Insert the electrical connector (1) of the HAP 200 into the 7-pin
terminal jack on the control unit, and lock in place by briefly
twisting clockwise.
5. Push the air hose of the HAP 200 (2) onto the "Air" nipple on the
control unit.
6. Turn on the control unit at the power switch and set the
temperature and air flow.
Also read and observe the operating instructions of your control
unit.
200 W
24 V AC
15 l/min
50 °C up to 550 °C
30 °C
5-6