Using The Remote Control - Sharp Eco inverter AY-XPM7RR Manual De Instrucciones

USING THE REMOTE CONTROL

LOADING BATTERIES
1
Remove the battery cover.
2
Insert two batteries. (AAA(R03))
• Make sure the (+) and (-) polarities are cor-
rectly aligned.
3
Reinstall the battery cover.
4
Press the RESET Button
• The display indicates "AM 6:00".
NOTE:
• The battery life is approximately 1 year in
normal use.
• Replace the batteries when the remote control
displays " ".
• Rechargeable batteries are not recommended
to use.
• When replacing the batteries, always change
both and use the same type.
• If you will not be using the unit for a long time,
remove the batteries from the remote control.
SETTING THE CURRENT TIME
There are two clock modes: 12-hour mode
and 24-hour mode.
1
To set the 12-hour mode, press the
CLOCK button once.
To set the 24-hour mode, press the
CLOCK button twice.
2
Press the TIME ADVANCE or
REVERSE button to set the current
time.
• Hold down the button to advance or
reverse the time quickly.
3
Press the SET/C button.
• The colon (:) blinks.
NOTE:
• The current time cannot be set when the timer
is set.
Battery cover
3
2
1
GB-4
USING THE REMOTE CONTROL
Point the remote control towards the receiver
window and press the desired button. The
unit generates a beep when it receives the
signal.
• Make sure nothing, such as curtains, block the
signal receiver window.
• The signal effective distance is 7 m.
7 m
CAUTION:
• Do not expose the receiver window to direct
sunlight. This may adversely affect its operation.
• Use of certain fl uorescent lamp in the same
room may interfere with transmission of the
signal.
• Do not leave the remote control in direct
sunlight or near a heater. Protect the remote
control from moisture and shock.
Receiver window