General Safety Regulations - Holmatro V-STRUT Manual Del Usuario

2.2 Pictograms on the equipment
Refer to Fig. 1.
All pictograms attached to the equipment pertaining to safety and danger must be complied with and
remain clearly legible.
WARNING
Not following these instructions can result in serious personal injury, fatal accident, damage
to the system or consequential loss.
/i
Type of mark Position
Instruction A.1
Warning A.2
A.9
Instruction A.3
A.4
A.5
A.10
A.6
A.11
A.7
A.8
Other labels attached to the equipment (refer to Fig. 1):
/i
Type of mark Position
Product label D
2.3

General safety regulations

• Use this equipment solely for the activities for which it was designed. If you are in doubt or
uncertain, always consult your Holmatro dealer.
• Replace illegible safety symbols, pictograms and information labels with identical ones, available
from your Holmatro dealer.
• Varnished, plastic and rubber parts are not resistant to corrosive acid or liquid. Rinse parts that have
come into contact with corrosive acid or liquid with a lot of water. Consult your Holmatro dealer for a
resistance list.
• Avoid an unhealthy posture while working. It can result in physical complaints.
• Follow the inspection and maintenance instructions.
• Conversion of the piece of equipment or the system may only be performed by a Holmatro Certified
Technician. In case of a conversion, retain the original manual and the conversion manual.
• Use only genuine Holmatro parts and maintenance products prescribed by Holmatro.
V-STRUT
Description
• Read the user manual before use.
• Wear a helmet with safety goggles/face shield.
• Wear safety gloves.
• Wear protective clothing that covers the entire
body.
• Wear safety shoes.
Maximum load-bearing capacity of strut (centric)
Minimum and maximum angle of use
Correct: both pawls have to interlock.
Incorrect: only 1 pawl is interlocking.
Incorrect: head is not loaded symmetrically.
Correct: head is loaded symmetrically.
Incorrect: vehicle is supported on 1 side only.
Correct: vehicle is supported on both sides.
Be careful for hot objects.
Put a cover between V-strut and sharp or hot objects.
Description
Identification label
916.001.337_001
EN
Part number
920.000.281
Part number
920.299.576
17