Removing Transport Guard From Line Cutter; Operation; Inserting And Removing Rechargeable Battery (04, 05); Adjusting Telescopic Handle (06) - AL-KO Energy Flex GT 4030 Manual De Instrucciones

GB
The temperature range for charging should be
between 5°C and +45°C. The charging time for
full charging is max. 120 minutes. If the operating
time of the rechargeable battery is reduced in
spite of it being fully charged, the rechargeable
battery is at the end of its service life and must be
replaced by a new original rechargeable battery.
For more information about charging the battery,
refer to the separate instructions for the battery
and the charger.
5.2 Removing transport guard from line
cutter
Remove the transport guard from the line cutter
before putting the appliance into operation for the
first time.

6 OPERATION

WARNING!
Risk of injury due to de-
taching appliance parts
Appliance parts detaching
during operation can lead
to serious injury.
■
Before turning the appli-
ance on, check that all
the parts of the appli-
ance are firmly
tightened.
■
Attach cutting tools so
that they cannot detach
during operation.
6.1 Inserting and removing rechargeable
battery (04, 05)
Inserting rechargeable battery (04)
1. Push rechargeable battery (04/2) into battery
slot (04/1) until it engages (04/a).
Removing rechargeable battery (05)
1. Press (05/a) and hold unlock button (05/1).
2. Pull out (05/b) rechargeable battery (05/2).
42
6.2

Adjusting telescopic handle (06)

1. Turn upper locking sleeve (06/1) to the right
(06/a) to release.
2. Adjust telescopic handle (06/2) individually to
a comfortable height. The telescopic handle
can be extended by approx. 10 cm (06/b).
3. Screw locking sleeve tight (06/c).
6.3

Swivelling cutter head (07, 08)

For trimming lawn edges, for example, it is pos-
sible to swivel the cutter head through 180° (07,
08).
1. Pull telescopic handle (07/1) slightly upwards
(07/a).
2. At the same time, turn cutter head (07/2)
through 180° (07/b) until it engages.
3. Allow the telescopic handle to slide down and
engage (07/a).
6.4

Tilting cutter head (09)

By changing the pivot angle, it is also possible to
trim areas that are difficult to access, e.g. under
benches, overhangs, etc.
1. Press (09/a) locking button (09/1).
2. Allow cutter head (09/2) to engage at the de-
sired angle (09/b).
3. Release the locking button.
6.5

Starting lawn trimmer (01)

1. Stand securely.
2. Hold the appliance with both hands. Do not
rest the cutter head on the ground when do-
ing this.
3. Hold auxiliary handle (01/5) in one hand and
upper grip (01/1) in the other hand.
4. Press unlock button (01/2).
5. Press and hold ON/OFF switch (01/2). The
appliance starts.
6. Allow the lawn trimmer to run at idling speed
for a few moments. This causes the cutting
line to be cut off to the correct length.
7. The appliance switches off when the ON/OFF
switch is released.
Operation
GT 4030