Super Ego 8870902 Manual De Instrucciones página 18

GB
User's manual
Setting up
1) Setting up:
Fix the mount base to the main body securely with the
bolts supplied (M8 X 25) and the four spring washers
(8 mm).
To attach the mount base, set it in the same direction
as the direction of the pipe threading machine.(Refer
to Figs. 2).
CAUTION
• Always set the mount base that matches the pipe
threading machine used. The mount base cannot be
attached to the pipe threading machine correctly if a
mount base for a different type is used.
Which pipe threading machine it can be attached to
is indicated on the rear of the mount base.
• If the mount base is attached in the opposite
direction to the rotating direction used, an
unnecessary load will be applied to the pipe
threading machine chuck, thereby resulting in
damage.
Be sure to attach the mount base so that it matches
the rotation direction used.
Spring
Ferward-Front Side
washer
(8mm)
2
Mount base
Bolt (M8 x 25)
2) To Attach the Connecting Shaft:
Insert the connecting shaft fully into the spindle then
fix the shaft on the spindle by tightening the two
screws against the flat surface of the spindle.
(See Fig. 4).
CAUTION
• Be sure to tighten the screws against the flat part
of the spindle as illustrated. If the cylindrical part
is tightened, the screws Will come loose during
grooving, and the spindle Will not turn properly.
Fixing screw
3) To Replace the Roller Set:
The standard roller specifications are for steel pipe
2"to 6".
Where other sizes of steel pipes are to be grooved,
replace the roller set (upper roller and spindle). The
appropriate sizes are stamped on: the roller (Fig. 5).
CAUTION
Be sure to replace the roller with the upper roller and
spindle as a set. If a wrong 0combination is used,
correct grooving will not be possible.
18
Spindle
Connecting shatt
Upper roller
Size
Spindle
4
5