Outside Top Exhaust - Beko CHS 30100 SS Manual De Usuario

4 Installing your appliance

Outside top exhaust

(Vertical duct–7" Round)
Use the diagram or the hood as a template and
mark the locations on the cabinet for ductwork,
electrical wiring and keyhole screw slots.
Outside rear exhaust
(Horizontal duct– 3 1/4"x 10" Rectangular)
• Use the diagram or the hood as a template and
mark the locations on the cabinet for ductwork,
electrical wiring and keyhole screw slots.
Recirculating
Use the hood as a template and mark the locations
on the cabinet for the electrical wiring and keyhole
screw slots.
Since the hood is to be recirculated (not to be
vented outside), do not cut out any vent openings
in the wall or cabinet bottom.
14 / 56 EN
Step 9
Choose Venting Option
The hood can be set to vent outside or to
recirculate air back into the kitchen.
The plastic vent lever is located near the center of
the hood opening.
To vent to the outside, make sure the plastic vent
lever is in the HORIZONTAL position (flat against
the metal top of the hood).
To recirculate air into the kitchen, make sure the
plastic vent lever is in the VERTICAL position (flat
against the plastic blower housing).
In order to change the vent lever
C
position, you will need to pull the
lever out slightly to clear the plastic
tabs.
Step 10
For recessed bottom cabinet only
If the cabinets have front, side or back trim, make
2 wood shims the width of the trim and attach
them to the cabinet bottom recess on both sides.
See previous page for marking locations.
Range Hood / User Manual