Samsung POWERbot SR1AM70 Serie Manual De Usuario página 35

<SR1AM7040W✴ / SR2AM70✴✴✴✴ series>
1
The information
code below
appears and
an information
codes alarm
sounds.
Information codes
1_VR7000_EN_DJ68-00763C-10_USA.indd 35
2
Turn off the
emergency
switch, check the
instructions below,
and then take
appropriate action.
The POWERbot is caught, stuck or trapped while
moving.
fTurn off the emergency switch, and then move the POWERbot to
another area.
Foreign matter is caught in the brush.
fTurn off the emergency switch, and then remove the foreign
matter from the brush.
Foreign matter is caught in the left Driving wheel.
fTurn off the emergency switch, and then remove the foreign
matter from the Driving wheel.
Foreign matter is caught in the right Driving wheel.
fTurn off the emergency switch, and then remove the foreign
matter from the Driving wheel.
The bumper sensor needs to be checked.
fTurn off the emergency switch, and then turn it back on.
fIf the information code does not disappear, check if there's any
foreign matter between the bumper and the main body. If there
is, pull the bumper slightly, and then remove the foreign matter.
Foreign matter has accumulated on the obstacle
sensor.
fTurn off the emergency switch, and then clean the front and
rear sensor with a soft cloth.
Foreign matter has accumulated on the cliff sensor.
fTurn off the emergency switch, and then clean the cliff sensor
with a soft cloth.
Main PCB needs to be checked.
fTurn off and restart the product. If the same problem occurs
repeatedly, a service check is required.
ENGLISH-35
3
The information
code will
disappear when
you turn on
the emergency
switch
Checklist
2017-12-01 오후 4:46:43