Rear Panel; Setup; Installation; Sound-Control - Futurelight CP-256 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Rear panel:

22
23
24
22) Audio input socket
23) Power supply socket
24) DMX output socket

5. Setup

5.1 Installation

Install the device on a plane surface.
Rack-installation: This device is built for 19" racks (483 mm). The rack you use should be a Double-Door-
Rack where you can open the frontpanel and the rear panel. The rack should be provided with a cooling fan.
When mounting the controller into the rack, please make sure that there is enough space around the device
so that the heated air can be passed on. Steady overheating will damage your device.
You can fix the controller with four screws M6 in the rack.
Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.

5.2 Sound-control

The sound-control either works via the ¼" mono jack-socket or the built-in microphone.
If the CP-256 is supposed to work via a soundsignal at the Audio In-socket, connect the ¼" jack socket with
the soundsignal of your headphones output or a second adjustable output (if existing) of your mixer, or with
the loud-speaker output of your amplifier.
Tip:
Data +
Sleeve: Ground
Caution: Never connect the sound input with the DMX-output, as this will destroy the electric (DMX-driver).

5.3 DMX-512 connection with the projector

Projector 1
Projector 2
Projector 3
Starting address 1
Starting address 17
Starting address 33
28

Publicidad

Tabla de contenido
loading

Tabla de contenido