VGE Blue lagoon Serie Manual De Instrucciones página 5

or knowledge, unless they are supervised or instructed on the use of the device by a person
responsible for their safety.
2. Warning - Risk of electric shock. If in doubt as to whether you have sufficient knowledge and
experience, this device must always be connected by a certified electrician, according to the
locally applicable standards and laws, with a properly earthed connection protected by a
residual-current device.
• Always remove the plug from the socket before carrying out maintenance or repair work on
the unit. Never put the plug in / pull the plug from the socket when you are standing in water
or if your hands are wet.
• Keep children away from this device and from the cable.
• The cable of the device cannot be replaced. In case of damage to the power cable, the
complete electrical unit must be replaced. Never remove the plug; leave the electrical unit
intact. An electrical unit with the plug removed will no longer be covered by the guarantee.
• Never install the unit in an area subject to full sunlight.
• Ensure that there is always water flowing through the unit when the lamp is on. Always install
the supplied flow switch (only for 130W amalgam).
• Once the device has been switched off, the lamp will remain hot for approximately 10 minutes.
• Do not use the device if any of the components are damaged (in particular the quartz glass and
the reactor).
• Remove the device if there is a risk of freezing during the winter months.
• The stainless steel housing of the device is not suitable for salt water baths with a high salt
content. If the salt content is too high, the steel will oxidise and can damage the reactor.
• This product can only be used according to the guidelines described in these instructions for use.
INSTALLATION OF THE EARTH (DRAWING 1)
1. Pull the cable (2) through the strain relief (4) before fitting the synthetic strain relief (4) onto the earth
bolt (1). Position the strain relief (4) at approximately 10 cm from the eye (2) of the earth cable.
2. Place the eye (2) of the cable onto the earth bolt that is fitted to the housing.
3. Then place a toothed lock washer (3).
4. Fit the strain relief (4), creating a loop of Ø5 cm.
5. Finally place the second toothed lock washer (5) and the lock nut (6) onto the earth bolt.
6. Once the parts have been placed onto the earth bolt in the correct sequence, they can be
tightened with a spanner or a ring spanner number 8.
INSTALLATION OF THE DEVICE (DRAWING 2)
The Blue Lagoon UV-C Timer must never be installed behind the Ph regulator or the salt electrolysis
system in your swimming pool installation. The ideal location to install your device is behind the
pump and the filter. Never submerge this device in water. The installation must always take place
outside of the pool. Ensure that there is always water flowing through the unit when the lamp is on.
UV-C and Pool equipment
BLUE LAGOON UV-C TIMER 40W, 75W & 130W AMALGAM |
EN
5