Replacing The Brushes - Polaris 9350 Sport Manual Del Propietário

Page 18
IMPORTANT
Cleaner power cable may become tangled if correct
procedure is not followed after each cleaning cycle.
After every cleaning cycle:
1. Unplug power to the cleaner at the control unit.
2. Remove the cleaner from the pool and untangle
all kinks and coils in the power cable starting
at the cleaner head. Lay the cable in the sun to
loosen any tangling memory.
3. Remove filter canister and rinse with clean
water. Plug power cord back into control unit
and store cleaner for next use.
6.3

Replacing the Brushes

The cleaner is fitted with PVC brushes. There are
''wear'' indicators on the brushes (Figure 29). To
maintain cleaner performance at its best you need
to replace the brushes as soon as one of the wear
indicators is reached (even if the blade wear is not
even). It is recommended that you replace the brushes
when the rubber is worn down to the top of the wear
indicator (or every two years, whichever comes first).
Figure 29. Wear Indicators
1. Lift the cleaner to a vertical position so that the
handle is up (Figure 30).
1
Figure 30. Cleaner in Upright Position
2. Separate the edges of the brush and undo the
tabs (Figure 31). Remove the worn brushes.