Replacing The Blade; Taking Out Of Operation; Spare Parts And Accessories; Technical Data - HellermannTyton EVO9 Manual De Instrucciones

Taking out of operation

9 .1 Replacing the blade

The blade should always be changed when the cable tie can no longer be cut-off neatly or easily.
CAUTION
The blade is sharp and could cause injury.
f Unscrew the nose piece screw
f Remove the nose piece
f Carefully remove the blade
f Insert a new and undamaged knife of the same size and design (see section "Spare parts and
accessories"). Observe the correct installation direction.
The installation direction is indicated by the bevelled corner
f Replace the nose piece.
f Tighten the screw for the blade holder.
10 Taking out of operation
When used for its intended purpose, the application tool will perform continuously without issues.
Should the application tool need to be withdrawn from operation, it must be disposed of correctly
in accordance with the country-specific disposal guidelines.

11 Spare parts and accessories

NOTE
The use of spare parts and accessories not approved by the manufacturer may lead to damage of the
application tool.
f Use only approved spare parts and accessories otherwise warranty claims shall be rendered void.
Spare parts and accessories can be procured direct from the respective HellermannTyton country
representative.
Spare parts / accessories
Blade
Fine adjustment tool CALTOOL

12 Technical data

Dimensions
TYPE
(L x H x W)
EVO9 191 x 135 x 33 mm
EVO9SP 191 x 135 x 33 mm
EVO9HT 191 x 135 x 33 mm
= Tension force
8
(Figure ) with a screwdriver.
1 G
.
2
.
3
Maximum
strap
width Weight
13.5 mm 0.359 kg
13.5 mm 0.359 kg
13.5 mm 0.359 kg
Operating Instructions • EVO9 | EVO9SP | EVO9HT • 06-2017 • 031-93351
(Figure ).
1 H
Article number
110-80037
110-70089
approx. 53 to 307 (factory setting)
approx. 53 to 307 (factory setting)
approx. 120 to 516 (factory setting)
Article
no .
110-80002
110-80003
110-80017