Publicidad
Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-0000000014-002.book Page 12 Tuesday, April 19, 2011 4:31 PM
en
12
Mounting the depth stop (figure 4).
Mount the depth stop with the 2 screws to
the bottom side of the gear case.
Changing the tool.
Before mounting or replacing
WARNING
application tools or accesso-
ries, remove the battery. This
preventive safety measure rules out the dan-
ger of injuries through accidental starting of
the power tool.
For all work or when changing
CAUTION
application tools, always wear
protective gloves. Danger of injury from the
sharp edges of the application tools. Applica-
tion tools can become very hot while work-
ing. Danger of burns!
The application tool can be offset in 30° steps
and fastened in the most favourable working
position.
When changing application
CAUTION
tools with sharp cutting
edges, use cover 3 21 74 011 00 0 to protect
yourself against hand injuries.
Also sharpen new blades with a sharpening
stone at the lowest oscillating frequency each
time before using.
The symptom for worn blades is a clearly
increased feed force at lower working
progress.
Fig. 4
Depth stop
Protect your hand and fingers
CAUTION
against bruising them when
locking the clamping lever.
The clamping lever snaps back vigorously by
means of spring force.
Release the clamping lever and tilt it to the
stop.
Pull out the fastening element.
Clean the tool holder, the application tool and
the fastening element.
Insert the application tool accurately into the
star-shaped tool holder. Pay attention that the
application tool is mounted flush.
Firmly press in the fastening element to
the stop. Then lock the clamping lever.
Fig. 5
180°
Clamping
lever
Screws
Fastening element
Cover
Publicidad
