Publicidad
Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-0000000251-001.book Page 15 Monday, February 8, 2016 12:04 PM
Working instructions.
Before mounting or replacing application tools or accessories, remove the bat-
WARNING
tery. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Do not use accessories not specifically intended and recommended for this power tool by FEIN.
The use of non-original FEIN accessories can lead to overheating of the power tool and destroy
it.
For each job, use only the FEIN application tool released and intended for the
CAUTION
respective application.
Switching on and off (figure 7).
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
The self-start prevention lock prevents the
power tool from automatically starting when
the battery is inserted while the on/off switch
is set to on.
Guide the power tool toward the work
piece only when switched on.
Switching on:
Push the switch toward the front (I).
Switching off:
Push the switch toward the rear ().
Setting the oscillating frequency
(figure 8).
Adjust the oscillating frequency infinitely vari-
able with the dial control.
Turn the dial control between "1" for the
lowest speed and "6" for the highest speed.
Fig. 7
Fig. 8
Thumbwheel for pre-selection
of oscillating frequency
6
5
4
3
en
15
On/Off switch
2
1
Publicidad
