Puky R1-R2002L Manual De Instrucciones página 12

Scooter Step
Replacing the V brake pads
Figure D: Undo the fastening nut of the
brake pad using an Allen key sized 5
mm (1) and replace the brake pads.
This means that the brake pads should
rest 1 mm below the top edge of the rim
(2). If these settings are not correct, loosen
the fastening nut of the brake pad (1) with
a 5 mm Allen key and align as described
above. To do so, pull the brake lever and
re-tighten the fastening nut (5-8 Nm).
The tension is to be set so that the brake pads
are all approximately 1.5 mm from the rims.
If subsequent adjustment is necessary, undo
the tensioning screw (3) and adjust the tension
(tighten the tensioning screw back up using
6-8 Nm!) or carry out the step described
in Figure C.
12