Hayward Tiger Shark RC9990CUB Manual Del Usuario página 12

TigerShark Plus
1. For installation and normal use of TigerShark Plus, please refer to the chapter on general use.
. In order for the remote control to operate properly, the power supply box must be placed in an
unobstructed location about twenty metres from the remote control. The remote control can be used at any
time during the cycle without the cycle being interrupted.
3. In order to control TigerShark Plus, press and hold the buttons of the remote control that correspond to
the action you wish to perform. Once you have released the button, TigerShark Plus automatically resumes
its normal cycle.
If TigerShark Plus does not operate when you press the button:
- Check that you are pointing the remote control towards the power supply box and not towards TigerShark.
- Check that there is no obstacle between the power supply box and the remote control
The distance between the power supply box and the remote control should be no longer than 0 metres.
The closer you are to the power supply box, the better the reception.
- Check the battery of the remote control: if necessary, replace it with a new battery (1x CR03 Lithium).
- The voltage surge protection might have tripped. Reactivate it by depressing the button located above the
connection of the TigerShark power supply cable on the power supply box.
- Check that the rotation actuator is not clogged with debris. For this purpose, remove TigerShark from the
water, and operate the actuator by hand to clear the debris: the actuator should be able to move easily.
1