Additional Safety Rules - Makita 6951 Manual De Instrucciones

ENGLISH
1 Bit
2 Sleeve
3 Switch trigger
4 Reversing switch lever
SPECIFICATIONS
Model
Capacities
Machine screw ................................. 4 mm – 8 mm
Standard bolt .................................. 6 mm – 12 mm
High tensile bolt ............................. 6 mm – 12 mm
Wood screw/Lag screw
(length) ...................................... 30 mm – 120 mm
No load speed (RPM) ................................ 0 – 2,200
Impacts per minute .................................... 0 – 3,000
Max. fastening torque .......................... 1,000 kg z cm
Overall length ............................................... 239 mm
Net weight ....................................................... 1.3 kg
• Due to our continuing program of research and
development, the specifications herein are subject
to change without notice.
• Note: Specifications may differ from country to
country.
Power supply
The tool should be connected only to a power supply
of the same voltage as indicated on the nameplate,
and can only be operated on single-phase AC supply.
They are double-insulated in accordance with Euro-
pean Standard and can, therefore, also be used from
sockets without earth wire.
Safety hints
For your own safety, please refer to the enclosed
safety instructions.

ADDITIONAL SAFETY RULES

1. Wear ear protectors.
2. Hold the tool firmly.
3. Always be sure you have a firm footing. Be
sure no one is below when using the tool in
high locations.
4. When driving into walls, floors or wherever
''live'' electrical wires may be encountered, DO
NOT TOUCH ANY METAL PARTS OF THE
TOOL! Hold the tool only by the insulated
grasping surfaces to prevent electric shock if
you drive into a ''live'' wire.
SAVE THESE INSTRUCTIONS.
4
Explanation of general view
5 Clockwise rotation
6 Counterclockwise rotation
7 Seconds
8 Fastening time
OPERATING INSTRUCTIONS
6951
Installing or removing bit
Important:
Always be sure that the tool is switched off and
unplugged before installing or removing the bit.
Use only the driver bit or socket bit shown in Fig. 1.
Do not use any other driver bit or socket bit.
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will
go. Then release the sleeve to secure the bit. (Fig. 2)
To remove the bit, pull the sleeve in the direction of
the arrow and pull the bit out firmly.
NOTE:
If the bit is not inserted deep enough into tne sleeve,
the sleeve will not return to its original position and the
bit will not be secured. In this case, try re-inserting the
bit according to the instructions above.
Switch action (Fig. 3)
CAUTION:
Before plugging in the tool, always check to see that
the switch trigger actuates properly and returns to the
''OFF'' position when released.
To start the tool, simply pull the trigger. Tool speed is
increased by increasing pressure on the trigger.
Release the trigger to stop.
Reversing switch action (Fig. 4)
CAUTION:
• Always check the direction of rotation before opera-
tion.
• Use the reversing switch only after the tool comes to
a complete stop. Changing the direction of rotation
before the tool stops may damage the tool.
This tool has a reversing switch to change the direc-
tion of rotation. Depress the reversing switch lever
from the A side for clockwise rotation or from the B
side for counterclockwise rotation.
9 Wood screw/Lag screw size
0 Limit mark
q Screwdriver
w Brush holder cap