Self Diagnostics Failure Code; Care Of Your Microwave Oven - Panasonic NE-1027 Manual De Instrucciones

The oven monitors its operation and displays a Failure Code in the dispaly window when a problem occurs.
What to do when a failure code appears:
CODE
F01
F33–34
F44
NOTE: ≥Above codes shown in the display do not indicate all the possible failures on the unit.
1. Unplug the oven before cleaning.
2. Keep the inside of the oven clean. when food
spatters or spilled liquids adhere to the oven
walls, wipe with a damp paper towel. Mild
detergent may be used if the oven gets very dirty.
The use of harsh detergent or abrasives is not
recommended.
3. The outside oven surfaces should be cleaned
with a damp paper towel. To prevent damage to
the operating parts inside the oven, water should
not be allowed to seep into the ventilation
openings.
4. If the Control Panel becomes dirty, clean it with a
soft, dry cloth. Do not use harsh detergents or
abrasives on the Control Panel. When cleaning
the Control Panel, leave the oven door open to
prevent the oven from accidentally turning on.
After cleaning, press the STOP/RESET Pad to
clear the display window or turn the TIMER
SELECT DIAL back to zero "0" position.

Self Diagnostics Failure Code

CAUSE
* Overcooked food
* Temperature of exhausted air is too
high
* Defective sensor circuit.
* When a pad was pressed for more
then 2 minutes
* Defective pad or control circuit.

Care of Your Microwave Oven

* Press Stop/Reset Pad to stop beep.
* Unplug the oven and wait at least
30 minutes before reconnecting.
* Wait for the oven to cool down and
reset.
* If a flame is observed, do not open
the oven door.
* If normal operation does not resume,
call the service agent with the
information of failure code.
* Unplug the oven and wait more than
10 seconds before reconnecting.
* If normal operation does not resume,
call the service agent with the
information of failure code.
5. If steam accumulates inside or around the
outside of the oven door, wipe with a soft paper
towel.
This may occur when the microwave oven is
operated under high humidity conditions and in
no way indicates malfunction of the unit.
6. Clean off the grease and dust on bottom surfaces
often. Use warm detergent solution.
7. This oven should only be serviced by qualified
person. For maintenance and repair of the oven
contact the nearest authorized dealer.
- 18 -
WHAT TO DO