Nylon Cutting Head - Dolmar LT-27 Instrucciones De Manejo

NYLON CUTTING HEAD

The nylon cutting head is a dual line trimmer head that has bump & feed
mechanism.
The nylon cutting head feeds out the nylon cord after tapping the trimmer head
on the ground.
Operation
– The most effective cutting area is shown by the shaded area.
– To feed the nylon cord, increase the nylon cutting head speed to approx.
6,000 min and tap the nylon cutting head lightly on the ground.
-1
– If the nylon cutting head does not feed out by tapping, rewind/replace the
nylon cord by following the procedures described under "Replacing the nylon
cord."
Replacing the nylon cord
– Stop the engine.
– Press the housing latches inward to lift off the cover, then remove the spool.
– Hook the center of new nylon cord into the notch in the center of the spool,
with one end of the cord extending about 80 mm (3-1/8") more than the other.
Then wind both ends firmly around the spool in the direction of the head
rotation (right-hand direction indicated by RH on the side of the spool).
– Wind all but about 150 mm (6") of the cords around the spool, leaving the
ends temporarily hooked through the notch on the side of the spool.
Press
80 mm (3-1/8")
Notches
13
Most effective cutting area
Cover
Latches
Spool
Spool
For right
hand rotation
150 mm (6")
Press