Optional Accessories - Dolmar AT-3724 U Manual De Instrucciones

Malfunction status
Motor does not run.
Motor stops running after a
little use.
It does not reach maximum
RPM.
Cutting tool does not rotate:
stop the machine
immediately!
Abnormal vibration:
stop the machine
immediately!
Cutting tool and motor
cannot stop:
Remove the battery
immediately!
014837

OPTIONAL ACCESSORIES

CAUTION:
• These accessories or attachments are recommended
for use with your Dolmar tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Dolmar Service Center.
• Cutter blade
• Nylon cutting head
• Nylon cord (cutting line)
• Dolmar genuine battery and charger
NOTE:
• Some items in the list may be included in the tool
package as standard accessories. They may differ
from country to country.
Cause
Battery cartridges are not installed.
Battery problem (under voltage)
The drive system does not work
correctly.
Rotation is in reverse.
Battery's charge level is low.
Overheating.
Battery is installed improperly.
Battery power is dropping.
The drive system does not work
correctly.
Foreign object such as a branch is
jammed between the guard and the
nylon cutting head.
Cutter blade fastening nut is loose.
The cutter blade is bended.
The drive system does not work
correctly.
One end of the nylon cord has been
broken.
The cutter blade is bended, cracked or
worn.
Cutter blade fastening nut is loose.
Cutter blade is fastened improperly.
The drive system does not work
correctly.
Electric or electronic malfunction.
Action
Install the battery cartridges.
Recharge the battery cartridge. If recharging is not
effective, replace battery cartridge.
Ask your local authorized service center for repair.
Change the direction of ratation with the reversing
switch.
Recharge the battery cartridge. If recharging is not
effective, replace battery cartridge.
Stop using of tool to allow it to cool down.
Install the battery cartridge as described in this
manual.
Recharge the battery cartridge. If recharging is not
effective, replace battery cartridge.
Ask your local authorized service center for repair.
Remove the foreign object.
Tighten the nut properly as described in this
manual.
Replace the cutter blade.
Ask your local authorized service center for repair.
Bump the nylon cutting head against the ground
while it is rotating to cause the cord to feed.
Replace the cutter blade.
Tighten the nut properly as described in this
manual.
Ask your local authorized service center for repair.
Remove the battery cartridge and ask your local
authorized service center for repair.
19