Publicidad
Idiomas disponibles
Idiomas disponibles
Drain Pump Mounting
Tab Slot
Vent Tube
NOTE"
Do
not
pinch,
kink
or damage
the vent
tube.
Check
that
it is not damaged,
or pinched
or kinked
between
the
cabinet
and
the
ice
maker.
A. Mounting
tab slot
Drain Pump Installed
°
A. Drain
pump
installed
8.
Align
the 2 screw
holes at the rear of the pump.
Use two
#8-32
x 3/8" screws, supplied.
See "Parts
Locations"
illustration.
9.
Connect
drain tube
to ice maker
bin outlet
(5/8" ID), using 7/8"
adjustable
clamp,
supplied.
See "Drain
Tube"
illustration.
10. Coil ice maker
power
cord
into a 4" (10.2 cm) diameter
coil.
Wrap
electrical
tape
around
the power
cord in several
places
to keep the cord in a coil.
Locate
coiled
power
cord
between
the drain pump
and side of enclosure
and plug
into
the receptacle
of the drain
pump.
See "Parts
Locations"
illustration.
11. Attach the drain pump power cord to ice maker unit base
with clamp and screw (removed in Step 6) that was used to
attach ice maker power cord. See "Parts Locations"
illustration.
12. Place new rear panel (small one for 15" ice makers, large
one for 18") against the back of the ice maker. Route the
vent tube and drain pump discharge tube through cutouts in
the rear panel.
13. Secure rear panel with original screws. See "Rear Panel"
illustration.
14. Secure
vent tube
to back
of ice maker
using 3 clamps
and
three
#8-32
x 3/8" screws,
supplied.
See "Vent
Tube"
illustration.
A.
Vent tube
B. Clamps
and
screws
15. Attach 1/2" ID x 10 ft (3 m) drain tube to pump discharge
tube. See "Parts Locations" illustration.
16. Connect ice maker to water supply and install ice maker as
specified
by the product installation
instructions.
17. Check all connections for leaks.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension
cord.
Failure to follow these instructions can result in death,
fire, or electrical
shock.
18. Plug in ice maker or reconnect power.
19. Turn on ice maker.
20. Wait for rinsing cycle, approximately
5 minutes, to be sure
the ice maker is operating
properly.
Publicidad
