Safety Instructions; Operating Manual - Energy Cost Measuring Instrument - Trotec BX11 Manual De Instrucciones

SAfEty INStrUctIONS

Please read this owner's manual carefully before you use your energy meter
and please make sure that this manual either remains with the device or is
kept within close range! Although this device was subjected to extensive
material, function and quality testing before it left our premises, this does
not mean that it does not present a hazard to the user or other persons if not
used properly or for purposes other than those for which it was intended!
Please note the following instructions.
• The guarantee expires with immediate effect in case of damage
which occurs a result of non-observance of these instructions . We
do not accept liability for any damages resulting there from!
• We do not accept liability for any damage caused to persons or prop-
erty when caused as a result of improper use or non-compliance
with these safety instructions! The guarantee expires with imme-
diate effect in all such cases . No changes or modifications may be
carried out on the device .
• Please make sure that the device is used properly . Be sure to follow
the instructions as described in this manual .
• The device may not be taken apart .
• Care must be taken to ensure that the protective earth conductor
is not interrupted as an interrupted protective earth conductor can
lead to fatal injury .
B - 1
• Connect the measuring instrument to the respective consumer
exclusively via the power cord . To avoid damage due to leverage
effects, never plug the consumer directly into the measuring instru-
ment, as it may be too heavy!
• Measuring devices are not toys . Keep away from children!
• Only connect to approved 230 V AC / 50 Hz (10/16 A) safety sock-
ets with protective earth conductor (VDE) (Association of German
Electricians) .
• The connected load may not exceed 3680 W (16 A) .
• The recommended operating temperature for this device is between
+5 and +40 °C . Higher temperatures, especially those encountered
when measuring larger consumers, can lead to overheating and re-
sult in irreparable damage to the device .
• Avoid using in hostile conditions where there are inflammable gases,
fumes or dust .
• For reasons of safety, do not allow anyone to use the device when
it is wet or in a damp environment . Make sure that the device is
disconnected from the mains before cleaning or maintenance work
is carried out .
• Accident prevention regulations in compliance with the standards as
laid down by the Association of Industrial and Commercial Workers
for Electrical Facilities and Equipment are to be observed at all times .
Operating manual – Energy cost measuring instrument EN