Functional Description - Makita AR411HR Manual De Instrucciones

4. To maintain product SAFETY and RELIABILITY,
maintenance and repairs should be performed
by Makita Authorized Service Centers, always
using Makita replacement parts.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product. MISUSE or failure to follow the safety
rules stated in this instruction manual may cause
serious personal injury.
INSTALLATION
Selecting air hose
CAUTION:
Low air output of the compressor,
or a long or smaller diameter air hose in rela-
tion to the screwdriving frequency may cause a
decrease in the driving capability of the tool.
Use a high pressure resistant air hose. Use an air hose
as large and as short as possible to assure continuous,
efficient screw-driving operation.
► Fig.2
Lubrication
Before and after use, apply two or three drops of pneu-
matic tool oil into the air fitting. After applying the oil,
connect the air hose and drive some screws for proper
lubrication.
► Fig.3: 1. Air fitting
FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the air hose
is disconnected and no fastener is loaded before
adjusting or checking function on the tool.
Driving depth adjuster
CAUTION:
When adjusting driving depth,
always disconnect the air hose.
This tool is equipped with an adjuster to change the
screw driving depth. Turn the adjuster to change the
driving depth. Driving adjustment range is 6 mm. One
turn of adjuster increases/decreases the depth by
approximately 0.8 mm.
► Fig.4: 1. Deeper 2. Shallower
Adjust the driving depth as necessary.
► Fig.5: 1. Driven too deep (turn clockwise)
2. Appropriate depth 3. Driven too shallow
(turn counterclockwise)
Hook
CAUTION:
When using the hook or changing
its position, always disconnect the air hose. Do
not fasten hook onto waist belt, etc. If the tool
dropped, it may be operated by mistake and cause
personal injury.
CAUTION:
Make sure that the hook is
attached to the tool properly. If unfastened, the
tool can drop and be operated by mistake, which
may cause personal injury.
The hook is useful for hanging up the tool temporarily.
Turn the hook while pushing the bottom. The hook can
be turned by 90°. You can change the mounting side
of the hook. Remove the screw fixing the hook and
change the direction.
► Fig.6
Driving mode switch
This tool is equipped with two types of driving mode.
Refer to the table below for selecting the driving mode.
The optimum driving mode varies according to the
workpiece material. Fully turn the knob until it clicks to
your desired mode position.
► Fig.7: 1. Knob
Screw length/
Material
Steel 0.8 mm
sheet thick
backing
0.6 mm
thick
0.4 mm
thick
Wood backing
When working on general plasterboard, the thickness
9.5 mm, 12.5 mm and 15 mm are suitable.
NOTICE:
Do not use the tool with the driving
mode switch halfway. Otherwise the tool will
be damaged and you may not be able to obtain
proper performance.
NOTICE:
The steel sheet backing thicker than
0.8mm cannot be worked with this tool. Also note
that screws cannot be driven into layered steel
sheet backing.
NOTICE:
Always use Makita genuine linked
screws.
NOTE: It is recommended to select the mode
ally. Set to the mode
lack of power.
8 ENGLISH
25 mm 28 mm 32 mm
-
-
-
if screws cannot be driven for
41 mm
usu-