Safety Notes; Installation Instructions; Technical Data; Symbol Description - Hansgrohe Aquno Select M81 170 3jet sBox 73831 Serie Instrucciones De Montaje

Safety Notes

Gloves should be worn during installation to prevent
crushing and cutting injuries.
The hot and cold supplies must be of equal
pressures.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.

Technical Data

Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
The product is exclusively designed for drinking water!

Symbol description

Do not use silicone containing acetic acid!
Adjustment (see page 41)
To adjust the hot water limiter. Using a hot water limiter
in combination with a continuous flow water heater is
not recommended.
Fault
SatinFlow too low / little water
Changeover to SatinFlow is stuck
Mixer dripping
To little water at the pull-out spout
Water escaping at the threaded
base
Pull-out length hose too short (less
than 500 mm)
4
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 70°C
max. 70°C / 4 min
Cause
- Nozzles and / or flow restrictor
fouled / calcified
- Changeover button fouled
- Cartridge defective
- Backflow preventer in the hose
connection and faucet aerator
calcified / fouled
- connection hoses not completely
screwed into basic body
- Hose weight assembled in wrong
position
Assembly (see page 33)
English
Maintenance (see page 56)
The check valves must be checked regularly according
to EN 806-5 in accordance with national or regional
regulations (at least once a year).
Dimensions (see page 42)
Flow diagram (see page 42)
Spare parts (see page 48)
XXX = Colors
000 = Chrome Plated
670 = Matt Black
800 = Stainless Steel Optic
Special accessories (order as an extra)
extension #43333000 (see page 47)
Cleaning (see page 56)
Operation (see page 50)
Hansgrohe recommends not to use as drinking water
65°C
the first half liter of water drawn in the morning or after
a prolonged period of non-use.
Test certificate (see page 50)
Remedy
- Dismantle and clean nozzles and
flow restrictor.
- Detach and clean changeover
button
- Exchange cartridge
- Clean backflow preventer and
faucet aerator
- Tighten connection hoses by hand
- Assemble hose weight according
to the assembly instructions