Lucci fini 210012 Manual De Instrucciones página 6

Installation Instructions
Fig. 4
NOTE:

Fan installation must be complete including assembly of blades before operating the remote control.

This remote control is only suitable where the controller/receiver can be inserted inside the canopy cover
safely and securely. Ceiling fans with mount bracket type shown in Fig. 4 would be suitable.

The controller wiring circuit must NOT be shared with any electrical equipment that is sensitive to
voltage fluctuation, such as flood lights with infrared sensor.

DO NOT use the wiring of the controller, other than for the purpose of supplying power into the controller,
and connections to the equipment that is under control. Any outside wiring connections which are not
part of the controller/controlled circuit may affect the operation of the controller and will void warranty.

The ceiling pitch should not exceed the fan hanging system maximum supported pitch. It will damage
the receiver and cause electric shock. Please check with retailer about pitch angle suitable for fan
mounting with remote control.

To avoid damage to the remote, DO NOT use in conjunction with fan wall controls that have speed
adjustment or light dimmer as function:
If the remote control device is to be installed with an existing ceiling fan with any of the above wall fan
controls, replace the fan wall control with the double pole ON/OFF switch shown below:
6 | P a g e