Emission Levels; Commissioning; Adjustments; Electronics - Festool OF 2200 EB Manual De Instrucciones Original/Lista De Piezas De Repuesto

-
The maximum rotational speed specifi ed on the
tool must not be exceeded and the rotational
speed range must be observed.
-
Do not use cracked or deformed router bits.
-
Do not clamp tools with an unsuitable shank di-
ameter in the clamping collet.
-
Wear suitable protection such as ear protec-
tion, safety goggles, a dust mask for work which
generates dust, and protective gloves when
working with raw materials and when changing
tools.
-
Festool electric power tools should only be in-
stalled in work benches specially designed by
Festool. The electric power tool may become
unsafe and cause serious accident if installed
in benches from other manufacturers or self-
manufactured work benches.

5.3 Emission levels

Noise levels are measured in accordance with EN
60745:
Sound pressure level
Noise level
Uncertainty
CAUTION
The noise produced during work can damage
your hearing.
Always use ear protection.
Overall vibration levels (vector sum for three direc-
tions) measured in accordance with EN 60745:
Vibration emission level
(3-axis)
Uncertainty
The emission values specifi ed (vibration, noise)
were measured in accordance with the test con-
ditions stipulated in EN 60745 and are intended
for machine comparisons. They are also used for
making preliminary estimates regarding vibration
and noise loads during operation.
The emission values specifi ed refer to the main
applications for which the power tool is used. If
the electric power tool is used for other applica-
tions, with other tools or is not maintained suf-
fi ciently prior to operation, however, the vibration
and noise load may be higher when the tool is
used. Take into account any machine idling times
and downtimes to estimate these values more
accurately for a specifi ed time period. This may
signifi cantly reduce the load during the machine
operating period.
6
Risk of accident if the machine is operated
using unauthorised voltages or frequencies.
The switch [2.2] is an on/off switch. Press the side
locking knob [2.1] to lock the switch for continu-
ous operation. Press the switch again to release
the knob.
7
L = 87 dB(A)
PA
L = 98 dB(A)
Risk of accident, electric shock
WA
K = 3 dB

7.1 Electronics

The OF 2200 EB features full-wave electronics
with the following properties:
Smooth start-up
The electronically controlled smooth start-up
function ensures that the machine starts up
smoothly.
2
a < 2,5 m/s
h
K = 1,5 m/s² Speed control
You can regulate the rotational speed steplessly
between 10000 and 22000 rpm using the adjust-
ing wheel [1.11]. This enables you to optimise the
cutting speed to suit the respective material and
routing tool:
Material
Hardwood
Softwood

Commissioning

WARNING
The mains voltage and the frequency of the
power source must correspond with the spec-
ifi cations on the machine's name plate.
In North America, only Festool machines with
the voltage specifi cations 120 V/60 Hz may be
used.

Adjustments

WARNING
Always pull the plug out of the socket before
performing any type of work on the machine.
Routing tool diameter
10 -30 30 - 50 50 - 89
Adjusting wheel setting
6 - 4
6 - 5
[mm]
HW
5 - 3 3 - 1
(HSS)
HSS
6 - 4 5 - 3
(HW)
15