Cleaning And Care - WMF SKYLINE Instrucciones De Uso

Note: The cup information given on the portion selector switch (5) is for guidance only. A different
setting may be required for different kinds of coffee, cup sizes, water hardness and also your personal
preference.
Test out which setting suits your personal preference.
The grinding process begins once the start/stop button has been pressed (6). The motor only runs if the
collection container (7) has been put in place properly.
Once the required amount of coffee has been ground, the mill shuts off automatically.
The grinding process can be interrupted at any time by pressing the start/stop button (6) again.
Wait until the motor has stopped before removing the collection container (7). Press down slightly
when removing the collection container (7). The coffee powder can be placed directly in the coffee
machine filter.
To avoid loss of aroma, coffee should only be milled for immediate use.
Excess coffee grounds can be kept in the collection container (7). Then close the collection container
(7) with the rubber cap (1).
Important information:
If the mill does not run, the motor may be obstructed by a bean. In this case select a higher degree of
fineness. Once the motor is running the desired degree of fineness can be immediately reselected after
start-up.
If the motor still does not start, or has difficulty starting up at the highest degree of fineness, clean
the mill as described under „Cleaning and Care".

Cleaning and care

Warning! Remove from the mains before cleaning. Under no circumstances submerge the device in
water - wipe the outside with a damp cloth instead.
Do not use scourers.
Remove the collection container (7) and clean with a mild cleaning product. Dry well before replacing
the collection container (7).
Remove the remaining beans before removing the bean hopper (3). Clean the bean hopper (3) and
bean hopper cap (2) in dish water and dry well. The mill can be opened when malfunctions occur or
for cleaning. Remove the bean hopper (3) and then remove the mill ring (8). Clean the mill and the
mill ring (8) with a small brush or the cleaning brush included in delivery (9).
8
Warning: The mill has sharp edges - there is danger of injury.
Replace the mill ring (8) and turn until it clicks into place and only
moves slightly.
Important: The safety ring must be turned in a clockwise direction as
far as it can go (see illustration) before the bean hopper (3) is replaced.
Otherwise the bean hopper (3) cannot be put back in place. Should
the safety ring be incorrectly replaced during cleaning, you can turn it
manually to the left.