Midwest Critter Nation 162 Manual De Instrucciones página 2

M Casters (4) -
Two locking, two non-locking. Inserted into
sleeves in the base
N Shelf (2) -
Wire structure with plastic sheet insert
O Phillips Head Bolts (8) with (8) Washers
P Flat Head Screws (2)
Q Swivel Locks (2)
R Phillips Head Screwdriver
ASSEMBLY INSTRUCTIONS
**NOTE: Although the Critter Nation can be
assembled by one person, due to size, you may
find it easier assembled with two people. A
rubber mallet is also recommended.
1.
Locate the Side Supports for the Base (K), two Base
Supports, one with multiple holes and one without
holes (L), and four Phillips Head Bolts with four
washers (O). Orientate the Side Supports so the
side with the holes in the tubes face inward and are
at the bottom. Attach the Base Support with multiple
holes to the bottom of the Side Supports and attach
the Base Support without holes to the top by
screwing a Phillips Head Bolt with Washer to outside
of each Side Support.
2.
Slightly separate the open ends of the base to allow
the Bottom Shelf Grid (E) to fit in. Align the
protruding wires with the holes in the base. Pull
sides back together.
3.
Attach the remaining Base Supports (L) to the Side
Supports by screwing a Phillips Head Bolt with
Washer to the outside of each Side Support. The
Base Support with multiple holes aligns with Bottom
Shelf Grid.
M
Non-Locking
Locking
O
Washer Bolt
Q P
1
2
3
N
R