Midwest Critter Nation 162 Manual De Instrucciones página 5

15.
Insert the Bottom Pan (H) in the bottom unit, and the
Middle Pan (I) in the upper unit. Be sure the cut-out is
positioned to match the opening in the Middle Panel
Grid Floor.
Note: The Shelves, in conjunction with the Side
Panels, can be positioned at 3 different levels on
either side of the cage.
Locate one Shelf (N). With the doors in the top unit
16.
open, tilt the Shelf down and insert the end of the hook
in the middle holes on the right side of the top unit. Lift
the Shelf up and let hook fall into place.
Before inserting the Shelf in the bottom unit, install the
17.
Ramp (J) that will allows access from one level to the
next. Attach the hooks on the end of the ramp to the
back wire in the opening of the Middle Panel Grid.
This ramp has the ability to be secured in the "up"
18.
position to section off the top level from the bottom
level. Before inserting the Shelf in the bottom unit,
swing this ramp up and hook it with the attached "S"
hook.
Install Shelf in bottom unit as in Step 16.
19.
Attatch the Ramp Clips to each ramp by inserting the
20.
two hooks on the ramp into the holes on the Ramp
Clips. The hooks on the ramp and the hooks on the
Ramp Clips should be facing the same direction.
Attach the Ramps to the Shelves by hooking the Ramp
21.
Clips to the wire on the Shelf as illustrated. The lip of
the plastic Shelf pan will cover the Ramp Clips.
15
3 Levels
17
18
2
Shelf
21
16
Side
Panel
Attach Ramp Clips
to Shelf Wire