Midwest Critter Nation 162 Manual De Instrucciones página 3

4. Locate the 4 Casters (M- 2 locking, 2 non-locking).
Insert the post of the caster into the pre-inserted
sleeve in the bottom of the Base. Be sure that the 2
locking casters are on one long side, and the 2
non-locking casters are on the opposite side. To fully
secure the casters in the sleeves, push the caster in
by hand or push down on the frame of the stand with
your hand or foot. (Note: The side with both locking
casters will now become the "front" of the cage.)
Locate the Door Panel (A) and insert the pegs into the
5.
outer-most holes of the Base Assembly. The Door
Panel should be inserted on the side of the stand that
has the two locking casters. Be sure the door locking
knobs face outward.
Locate the Bottom Floor Panel Grid (F) and insert the
6.
protruding wires into the corresponding holes of the
Door Panel. Be sure the wires that run front to back
on the grid are on the top.
7.
Locate the Back Panel (B) and insert one peg in one
of the back, outer-most holes. Be sure the protruding
rectangular openings are facing inward. While slightly
lifting the Bottom Floor Panel Grid, swing the other
end of the back panel around, aligning the protruding
wires of the Grid with the holes in the Back Panel.
When they are all lined up and inserted, put the peg
in the outer-most hole.
8. Locate two of the Side Panels (C). Insert the pegs
into the holes between the Door and Back Panels. Be
sure the cut-outs on the bottom go around the
protruding wires of the Bottom Floor Panel Grid. Insert
the protruding tabs at the top of the panels into the
protruding openings in the Door and Back Panels to
lock the panels together.
4
Back
7
6
8
Front
5