Contrast Adjustment; Dimmer; System Q Setting; Switching Preout - Kenwood KDC-X569 Manual De Instrucciones

Contrast Adjustment

Adjusting the display contrast.
Display and Setting
"Contrast 0"/ "CONT 0"
"Contrast 5"/ "CONT 5" (Original setting)
"Contrast 10"/ "CONT 7"
Function of the KDC-X569/MP522/MPV622/MPV6022/X469/422/4022

Dimmer

Dimming this unit's display automatically when the vehicle light
switch is turned ON.
Display
"Dimmer ON"
"Dimmer OFF"

System Q Setting

Setting display/don't display for the System Q factors (Bass
center frequency, Bass Q factor, Bass extend, Middle center
frequency, Middle Q factor, and Treble center frequency) in
Audio control.
Display Setting
"System Q ON" The System Q factors are displayed.
"System Q OFF" The System Q factors aren't displayed.
Setting
The display dims.
The display doesn't dim.
Function of the KDC-X569/KDC-X469
Function of the KDC-MP522/MPV622/MPV6022/422/4022

Switching preout

Switching the preout between the rear and non-fading. (In non-
fading it outputs without effect from the fader control.)
Display
"SWPRE Rear"
"SWPRE N-Fad"

Built-in Amp Mute Setting

Toggles ON or OFF the mute control on the built-in amplifier.
Turning ON this control enhances the preout quality.
Display
"AMP Mute Off"
"AMP Mute On"
— 25 —
<In Standby mode>
Setting
Rear preout.
Non-fading preout.
Function of the KDC-X569/KDC-X469
<In Standby mode>
Setting
The built-in amplifier activates.
The built-in amplifier deactivates.