Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting Guide
The messages shown below display your systems
condition.
Eject/ EJECT:
No disc magazine has been loaded in the changer. The
disc magazine is not completely
➪ Load the disc magazine properly.
No CD in the unit.
➪ Insert the CD.
No Disc/ NO DISC:
No disc has been loaded in the disc
➪ Load a disc into the disc magazine.
TOC Error/ TOC ER:
No disc has been loaded in the disc
➪ Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-down. The CD is
scratched a lot.
➪ Clean the CD and load it correctly.
E-05:
The CD is
upside-down.E05
➪ Load the CD correctly.
Blank Disc/ BLANK:
Nothing has been recorded on the
No Track/ NO TRACK: No tracks are recorded on the MD, although it has a
title.E11
E-15:
Media was played that doesn't have data recorded that
the unit can play.
➪ Use media that has data recorded that the unit can
play.
No Panel/ NO PANEL: The faceplate of the slave unit being connected to this
unit has been
➪ Replace it.
E-77:
The unit is malfunctioning for some
➪ Press the reset button on the unit. If the "E-77" code
does not disappear, consult your nearest service
center.
Mecha Error/ MECHA ER:
Something is wrong with the disc magazine. Or the unit
is malfunctioning for some
➪ Check the disc magazine. And then press the reset
button on the unit. If the "Mecha Error"/ "MECHA ER"
code does not disappear, consult your nearest
service center.
loaded.E01
magazine.E02
magazine.E04
MD.E10
E15
removed.E30
reason.E77
reason.E99
Hold Error/ HOLD ER:
The protective circuit in the unit activates when the
temperature inside the automatic disc changer exceeds 60°C
(140°F), stopping all
➪ Cool down the unit by opening the windows or turning on
the air conditioner. As the temperature falls below 60°C
(140°F), the disc will start playing again.
NO NAME:
Attempted to display DNPS during the CD play having no disc
names
preset.E51
Load/ LOAD:
Discs are being exchanged in the Disc
Reading:
The unit is reading the data on the
NO ACCESS:
After setting it in the Disc Changer, DNPP was done without
having it been played at least 1
IN (Blink):
The CD player section is not operating
➪ Reinsert the CD. If the CD cannot be ejected or the display
continues to flash even when the CD has been properly
reinserted, please switch off the power and consult your
nearest service center.
— 37 —
operation.E0d
changer.E57-1
disc.E57-2
time.E58
properly.E59
Publicidad
Capítulos
Tabla de contenido
