HumanTechnik lisa RF time Instrucciones De Servicio página 9

Thank you for choosing the lisa RF
time. You have purchased a modern
and reliable alerting system.
The lisa RF time alarm clock is an
electronic clock with an analog dial.
It is also a complete receiver for the
lisa radio transmitters. It possesses
a powerful vibrating pad, which
alerts you to a signal, as well as 6
LEDs which indicate the type of sig-
nals that are being received.
Standard components
- lisa RF time
- vibrating pad
- 230 V power supply unit
Installing the lisa RF time
Open the battery compartment of the
lisa RF time and remove the paper at
the + contact of the battery.
Connect the mains power supply unit
to the lisa RF time and plug into a
mains socket.
Time setting
Lightly pull the time and alarm set-
ting knob and turn it in the direction
of the arrow.
Warning: Pull the knob out carefully
and only turn it in the direction of
the arrow!
Alarm setting
Turn the time and alarm setting knob
in the direction of the arrow.
Switching on the alarm
Push the Alarm On/Off button. When
you see the green marking the alarm
is on.
Switching on the sound
Push the Sound On/Off button. When
you see the green marking the sound
is on.
Snooze Alarm
Touching the Light/Snooze
Alarm/lisa signal cancel switch will
stop the alarm and it will start again
in approximately
5 minutes.
Face illumination (back light)
Touching the Light/Snooze
Alarm/lisa signal cancel switch will
light the face for approx 4 seconds.
Setting the correct radio channel
A special digital transmission pro-
cess ensures that the radio signals
are received error-free. This process
also makes it possible to set 10 dif-
ferent radio channels. When sup-
plied from the factory, the lisa RF
time is set to channel 0. It is only
necessary to set units to other chan-
nels if you have several different
users operating units in the same
building. Set the channel you want
by adjusting the channel selector
switch on the underside of the unit
English 9