Onkyo DAC-HA300 Manual De Instrucciones página 7

B
Digital audio input/output and
analog audio input jack
Use this for digital audio input/output or analog audio input.
o The unit will automatically switch between optical and coaxial
connections.
For digital input:
Optical connection: Use an optical cable with a mini plug.
Coaxial connection: Use the included RCA conversion cable.
For analog input:
Use a cable with a 3.5 mm stereo mini plug.
For digital output:
Coaxial connection: Use the included RCA conversion cable.
C
Digital/analog switch
Use this to switch between digital input/output and analog input.
If the switch and the cable connected to the connection jack do
not match, audio input and output will not be possible.
o Use the SETTINGS screen to switch digital input and output.
D
PHONES jack
Connect a headphones plug (3.5 mm stereo mini) to this jack.
CAUTION
o Always minimize the volume before plugging headphones in and
putting them on. While wearing headphones, do not connect or
disconnect them or turn the unit on or off. Doing so could result
in a sudden loud noise that could harm your hearing.
o Be careful not to mistake the headphones jack for the digital out-
put jack and vice versa. Doing so could result in odd noises and
even damage to connected equipment.
E
GAIN switch
Use this to change the output level to suit the headphones that
you are using.
H: high output level
L: low output level
Lower the volume before setting this switch to H.
CAUTION
Particularly when using headphones for the first time with this unit,
set the GAIN switch to L and be sure to raise the volume gradually
during playback to check the sound pressure sensitivity.
F
Power/volume knob
Turn this counterclockwise until it stops to turn the unit off.
Use this to adjust the volume. Turn this clockwise to turn the unit
on. Keep turning it clockwise to increase the volume. Turn it coun-
terclockwise to decrease the volume.
Continued on the next page
e
EN
7