Before Use - Esoteric D-02 Manual Del Usuario

Read this before attempting any operations.
Placement of the unit
This unit is heavy. Take care to prevent injuries when lifting and
installing it.
< High-quality tool steel is used for the spike feet, securely attached
to the bottom of the unit. Although the outer feet may appear
loose, the weight of the unit causes them to become firm and
secure. The design effectively damps and reduces vibration.
Spike foot
Protection foot
To protect the supporting furniture surface, you may stick the
supplied felt pads to the bottom of the protection feet.
o Place the unit in a stable location near the audio system that you
will use.
o Choose the installation location of your unit carefully. Avoid placing
it in direct sunlight or close to a source of heat. Also avoid locations
subject to vibrations and excessive dust, heat, cold or moisture.
o As the unit may become warm during operation, always leave
sufficient space around the unit for ventilation.
Make sure there is at least 8" (20 cm) of space above and at least 2"
(5 cm) of space on each side of the unit.
When you install the unit in a rack, use one which has ventlations
and take care of temperature of the unit.
o Do not place this unit on a thick carpet.
o When the unit is turned on, switching on the TV may cause lines
to appear on the TV screen, depending on the condition of the
electric waves of the TV broadcast. This is not malfunction in the
unit or the TV. If you see such lines, keep this unit well away from
the TV set.

Before Use

Bottom plate
of the unit
Retaining screws
CAUTION
o Do not place any objects on this unit.
o Do not cover this unit with a cloth.
o The voltage supplied to the unit should match the voltage as
printed on the rear panel. If you are in any doubt regarding this
matter, consult an electrician.
o Do not open the cabinet as this might result in damage to the
circuitry or cause electric shock. If a foreign object should get into
the unit, contact your dealer or service company.
o When removing the power plug from the wall outlet, always pull
directly on the plug, never yank on the cord.
Maintenance
If the surface of the unit gets dirty, wipe it with a soft cloth or
use diluted mild liquid soap. Allow the surface of the unit to dry
completely before using.
For safety, disconnect the power cord from the socket before
cleaning.
o Never spray liquid directly on this unit.
o Do not use thinner or alcohol as they could damage the surface of
the unit.
o Avoid allowing rubber or plastic materials to touch this product for
long periods of time. It could damage the cabinet.
5 5