Tabla de contenido
Publicidad
Assembly Instructions and Parts List
Power Cord
1. Plug the power cord into a ground-
ed 120V outlet and press the reset
button as shown in figure 3.
2. THIS MUST BE DONE EACH TIME THE
UNIT IS PLUGGED IN AN OUTLET.
Reset
Figure 3 - Grounded plug/reset button
www.chpower.com
! IMPORTANT !
This pressure washer is equipped with a
microswitch sensitive to water flow. This
Instant Start/Stop switch (ISS) senses
water flow in the pump. When the trig-
ger is released, water stops flowing
through the pump. The ISS then auto-
matically turns the motor off to protect
pump from overheating.
OPERATION
1. Pull trigger on gun and hold.
2. Turn the "ON/OFF" switch to "ON".
3. Release trigger. The pressure washer
motor will stop running.
4. To spray again, pull trigger and motor
and pump will restart.
Note: Occasionally the motor may run
for a short time to bring fresh, cool
water into the pump even if trigger is
released. This is part of normal opera-
tion and will not damage the unit.
CAUTION
!
"OFF," then trigger gun to release hose
pressure before unplugging power
cord.
CAUTION
!
the "ON/OFF" switch on the unit is
"OFF" and unit is unplugged prior to
storage.
WARNING
!
when trigger is squeezed if on/off
switch is in "ON" position. Always point
gun in safe direction.
Call 1-800-330-0712
for Technical Service
2
PW132000AV
Always turn the
"ON/OFF" switch to
Risk of equipment dam-
age. Always make sure
Risk of Injection.
Unit will start spraying
Publicidad
Tabla de contenido
