Tabla de contenido
Publicidad
Assembly Instructions and Parts List
Garden Hose Connection
GARDEN HOSE CONNECTION
INSTRUCTIONS
1. Attach nipple adapter to inlet fitting
on the unit (this may already be
attached to the pump).
2. Attach quick connect fitting to
den hose.
3. Pull side "A" of quick connect fitting
toward garden hose and push onto
nipple adapter.
4. Push side "A" of quick connect fitting
towards nipple adapter and release.
"A"
Nipple
Adapter
Figure 5 - Garden Hose Connection
Power Cord
1. Plug the power cord into a ground-
ed 120V outlet and press the reset
button as shown in figure 6.
2. THIS MUST BE DONE EACH TIME THE
UNIT IS PLUGGED IN AN OUTLET.
Reset
Figure 6 - Grounded plug/reset button
www.chpower.com
Quick Connect Fitting
Garden Hose
This pressure washer is equipped with a
microswitch sensitive to water flow. This
Instant Start/Stop switch (ISS) senses
water flow in the pump. When the trig-
ger is released, water stops flowing
gar-
through the pump. The ISS then auto-
matically turns the motor off to protect
pump from overheating.
OPERATION
1. Pull trigger on gun.
2. Turn the "ON/OFF" switch to "ON".
3. Release trigger. The pressure washer
motor will stop running.
4. To spray again, pull trigger and motor
and pump will restart.
Note: Occasionally the motor may run
for a short time to bring fresh, cool
water into the pump even if trigger is
released. This is part of normal opera-
tion and will not damage the unit.
CAUTION
!
then trigger gun to release hose pres-
sure before unplugging power cord.
CAUTION
!
the "ON/OFF" switch on the unit is
"OFF" and unit is unplugged prior to
storage.
WARNING
!
when trigger is squeezed if on/off
switch is in "ON" position. Always
point gun in safe direction.
2
PW138012AV
! IMPORTANT !
Always turn the
"ON/OFF" switch to "OFF"
Risk of equipment dam-
age. Always make sure
Risk of Injection.
Unit will start spraying
Call 1-800-330-0712
for Technical Service
Publicidad
Tabla de contenido
