Changing Batteries; To Use - Beurer FT 58 Instrucciones De Uso

3. Continue in this fashion to set hour, minute, year, month, and day in turn.
4. After the day is set, press the "
will shut off.
Selecting a temperature scale (°F or °C):
1. With the device switched off, press and hold the START button for three
seconds; "°F" appears in the LCD Display.
2. Press the START Button to select °F or °C and then press the "
Button to save and exit.

Changing batteries:

Two AAA batteries are pre-installed and should last for about 3,000 measurements. When battery power
gets low, the low battery icon "
appears on the display.
1. Shut the thermometer off.
2. Slide the Battery Compartment Cover toward the bottom of the thermometer to remove.
3. Remove the old batteries and replace with two new AAA alkaline batteries, following the polarity markings
inside the compartment. Reattach the Battery Compartment Cover.

5. To Use

NOTE:
• Check before each use that the lens is intact. If it is damaged, contact your retailer or the service
address. Bear in mind that the ear thermometer needs to have been in the room in which the
measurement is taken for at least 30 minutes before use.
Ear Temperature Measurement:
1. Place a clean Protective Cover onto the sensor.
2. Press the ON/OFF Button "
beep three times and the LCD Display will activate.
" Button to save and exit; the device
" appears. Replace the batteries as soon as the battery symbol "
" to switch the thermometer on; it will
6
"
->
"