Start Up; Loading The Sand Filter - fluidra ASTRALPOOL Compact kit Manual De Instrucciones

START-UP
3. START-UP
Once the whole installation has been assembled and before filling the sand filter, it is advisable to
start-up the system to check that all components work properly and that there are no leaks.

3.1. LOADING THE SAND FILTER

For maximum performance of the filter, it is recommended to use sand with a granulometry of 0.4
to 0.8 mm. The amount to use is indicated on the specifications plate of the filter.
To correctly fill the filter, follow the steps indicated below:
1. Remove the cover and the filter joint, taking care not to damage the joint.
2. Check that all collector arms are in good condition.
3. Carefully fill with water halfway.
4. Pour in the sand contents indicated on the label, taking care to protect the diffuser and
avoiding damage to the collector arms.
5. Remove the protection from the diffuser and place the cover, having first cleaned the
sand and waste from the closing area.
6. Fill the Spa with water.
7. Wash the filter so that it is ready for operation.
During the filling process, ensure that water does not leak into electrical parts.
Sea water in the Spa will quickly lead to general deterioration of all components of the circuit.
Do not fill the Spa will water warmer than 50ºC, as this may trigger the safety thermostat
Once the Spa is full of water, connect the electrical equipment by placing the differential switch
in the ON position. (See Electrical Connection section).
Check that the differential switch works correctly. Press the test button and the differential
switch should automatically go from the ON position to the OFF position.
16 Compact Kit for private use - Operating Instructions
ATTENTION
Carefully read the following points before starting-up the Spa.
ATTENTION
and damage equipment and connections.
ATTENTION
Do not use the Spa unless you have read the Spa Manual.