Remote Control - Cardin Elettronica SL Serie Manual Del Usuario

REMOTE CONTROL

The system can be remotely activated using radio control devices; each channel has a choice of 8 possible functions: opening closing -
limited opening - sequential command - CH2 output - block - events ON/OFF - no command.
To set the functions to channels 'A','B','C','D' use the command 'CHANNEL FUNCTIONS' from the
mand may be set to 'open-stop-close-stop' or 'open-close'.
TRANSMITTER CODE MANAGEMENT
Memorising a channel
1) Scroll to the
MEMORISE
on the LCD.
2) Activate the transmitter channel that is to be memorised: the indication 'Activation 2' will flash on the LCD.
3) Activate the transmitter again (same transmitter, same channel*): the indication 'COD. MEMORISED' will flash on the LCD.
The number of channels already present in the memory is shown on the first line in brackets.
Note: It is not possible to memorise a code which is already in memory: if you attempt this the indication 'COD. IN MEM.' (point one) will
appear on the LCD.
Cancelling a channel
1) Scroll to the step in the
CANCEL
LCD.
2) Activate the transmitter channel that is to be cancelled: the indication 'Activation 2' will flash on the LCD..
3) Activate the transmitter again (same transmitter, same channel*): the indication 'COD. CANCELLED' will flash on the LCD.
The number of channels already present in the memory is shown on the first line in brackets.
Note: It is not possible to cancel a code which has not been memorised: if you attempt this the indication 'COD. NON MEM.' (point one)
will appear on the LCD.
*
if the channel is different or it is a different transmitter (point three) the memorisation attempt will abort without success however 'Activation 1' will
still flash on the LCD.
menu and confirm using the 'PROG/OK' button: the indication 'Activation 1' will flash
step in the
REMOTE
menu and confirm using the 'PROG/OK' button: the indication 'Activation 1' will flash on the
REMOTE
83
menu. The sequential com-
REMOTE