iSi Nitro Modo De Empleo página 16

chargers or chargers from different manu-
facturers than stated in the Whipper Data.
——— When screwing on the charger, keep face
away from the whipper; do not bend over
the whipper!
——— The whipper is a pressure equipment. If
it is dropped or damaged (e.g., cracked
or dented), do not use it again because it
poses a risk of injury. Please have the whip-
per checked by the iSi service center!
——— Never unscrew the head when the
whipper is pressurized!
——— Never use the lever as a carrying handle!
——— Proper cleaning is a mandatory require-
ment in order to avoid the whipper becom-
ing blocked. Make sure, the iSi Whipper has
been properly cleaned before use!
——— Only dismantle the iSi Whipper for cleaning
in accordance with the illustration!
——— Before cleaning, check the material
compatibility of the cleaning solution and
disinfectant solution used!
——— Do not make any modifications to the iSi
Whipper. This will void the warranty and
exempt the company from any liability!
——— Pay attention to the maximum number of
chargers to be used indicated in the Whip-
per Data.
——— Never overfill the whipper. This will ensure
that the specified maximum operating
pressure is not exceeded!
——— If the pressure will not release, please
contact iSi or your service center!
NOTE: Before using the iSi Whipper for the
first time, remove the yellow transporta-
tion lock from the piston thread. Carry out
thorough cleaning as shown in the Cleaning
illustration. Please observe the illustrations
at the beginning of the booklet.
8