Fm Radio; Audio Settings - Scansonic R110 Manual Del Usuario

R110

FM radio

FM radio mode receives analogue radio from the FM band.
To enter FM mode, press Mode until the display shows FM radio or
press FM on the remote control.
Selecting stations
To find a station, press Select. The frequency display to count as the unit scans the FM band.
Alternatively, you can scan up or down by pressing the Up or Down button or press and hold the
l>> or <<l on the remote control.
Presets
To store a station as a preset, press and hold Preset until the display shows the Save to preset
screen. Select one of the 10 presets and press Select to save.
To select a preset, press Preset briefly, then select one of the listed presets.
Scan settings
By default, FM scans stops at any Available station. This may result in a poor signal to noise ratio
(hiss) from weak stations.
To change the scan settings to stop only at stations with good signal strength, select Menu > Scan
setting and change option to Yes.

Audio settings

By default, all stereo stations are reproduced in stereo. For weak stations this may result in a poor
signal to noise ratio (hiss).
To play weak stations in mono, select Menu > Audio setting and change option to Yes.
10