Getting Started/Setup; Auto-Update - Scansonic R110 Manual Del Usuario

Getting started/setup

Setup wizard
When Scansonic R110 is started for the first time, it runs through a
setup wizard to configure settings for date/time and network.
Note: If you want to use wired network, you can bypass the wizard.
Select YES to start the setup wizard.
Note: If power is removed while the wizard is in progress, the wizard will run again next time the
unit is started.
12/24 hour display
To change between 12 and 24 hour display.
Time/Date
The time and date can be updated manually or automatically. With
auto-update, the time and date are automatically synchronize with
external clocks.

Auto-update

DAB uses time signals from DAB stations.
FM uses time signals from FM radio broadcasts.
Network uses time signal from Frontier Silicon Internet radio portal.
1. Select Update from DAB, FM, Network or No update.
2. Set your timezone
3. If your country uses daylight saving,
Manual set
If you set No update, the wizard now prompts you to set time and
date manually.
The date and time are displayed as dd-mm-yyyy and hh:mm AM/
PM with the active value flashing.
Adjust each value with the Select.
R110
7