Publicidad
Idiomas disponibles
Idiomas disponibles
Fuse
ill&i
WARNING!
Before servicing,
repairing,
or
inspecting,
always disengage
PTO, set parking
brake, stop engine and remove
key to prevent
unintended
starting.
A fuse is installed
in your tractor's wiring
harness to protect
the
tractor's
electrical
system from damage
caused by excessive
amperage.
If the electrical
system does not function,
or your tractor's
engine
will not crank, check to be certain that the fuse has not blown.
It
is located
under the hood, mounted
behind
the top of the dash
panel on the support
bar.
i_i
CAUTION:
Always use a replacement
fuse with the
same amperage
capacity
as the blown
fuse.
Tires
WARNING!
Never exceed the maximum
inflation
pressure shown on the sidewall
of the tire.
Refer to the tire sidewall
for exact tire manufacturer's
recommended
or maximum
psi. Do not overinflate.
Uneven tire pressure could cause the cutting
deck to mow
unevenly.
Changingthe Transmission Drive Belt
Several components
must be removed
and special tools used in
order to change the tractor's transmission
drive belt. See your
Cub Cadet dealer to have the transmission
drive belt replaced.
Changingthe DeckBelt
WARNING!
Shut the engine off and remove
ignition
key before removing
the cutting
blade(s) for
sharpening
or replacement.
Protect your hands by
using heavy gloves when grasping
blades and
pulleys.
WARNING!
The V-belts found
on your tractor
are
specially designed
to engage and disengage
safely.
A substitute
(non-OEM)
V-belt can be dangerous
by
not disengaging
completely.
For a proper working
machine,
use factory approved
belts.
All belts on your tractor are subject
to wear and should
be
replaced
if any signs of wear are present. To change or replace
the deck belt on your tractor, proceed
as follows:
1.
Remove the deck as instructed
on page 24.
2.
Remove the belt guards by removing
the hex screws that
fasten them to the deck. See Fig. 7-7.
Figure 7-7
3.
Loosen, but do not remove the belt keeper
rod on the
pulley located
near the back of the deck. See Fig. 7-7.
4.
Carefully
remove the deck belt from around the three
spindle
pulleys and the two deck idler pulleys.
SECTION 7 -- SERVICE
27
Publicidad
