Publicidad
Idiomas disponibles
Idiomas disponibles
5.
To place the new belt begin by routing
the belt around the
two outer spindle
pulleys, then around the front spindle
pulley as shown in Fig. 7-8.
f
Outer Spindle
Pulleys
Figure 7-8
6.
Route the belt around
the two deck idler pulleys as shown
in Fig. 7-8.
7.
Retighten
the belt keeper rod loosened
earlier.
8.
Remount
the belt guards removed
earlier.
9.
Re-install
the deck making
sure the belt remains routed
around the pulleys as instructed.
10.
Pull the right side of the belt and place the narrowV
side of
the belt into the PTO pulley. See Fig. 7-9.
PTO Belt
J
11.
Figure 7-g
While holding
the belt and pulley together,
rotate the
pulley to the left (See Fig. 7-9). Continue
holding
and
rotating
the pulley and belt until the belt is fully rolled into
the PTO pulley.
SECTION 7--
SERVICE
Publicidad
