Cutting; Cutting Remainders; After Cutting - Graef Concept Serie Instrucciones De Servicio

5.2 Cutting

Check the protective devices according to point 3.7.
Provided that the same operator touches the product and the controls,
they must be cleaned between every usage!
- Pull back the slide completely.
- Lift the end-piece holder.
- Put the cutting material on the rear wall of the slide.
- Put the end-piece holder on top of the cutting material.
- Press the ON button. The machine is started.
- Set the cutting thickness by using the cutting thickness controller.
- For cutting, push the slide forward and backward while
guiding the cutting material to the stop plate by slight pressure with the hand.
- At the end of the cutting process, completely close
the stop plate and switch off the machine using the red "Off button".

5.3 Cutting remainders

- Pull back the slide completely.
- Pull the holder for remainders outwards and lift it.
- Tied up end pieces: cut off the
tied up end using the hand knife
- Insert the end piece with the original cut surface into the direction of the top plate
on the slide back wall.
- Lower the end-piece holder and set it behind the end piece
- Switch on machine. The blade is rotating.
- Set the cutting thickness
- Using the end-piece holder, press the end piece by applying slight pressure against
the stop plate and then push the slide forward and backward
- At the end of the cutting process, completely close
the stop plate and switch off the machine using the red "Off button".

5.4 After cutting

- Basically, switch off machine
- Always close the stop plate completely so that the blade edge is fully covered.
43