Garland 790 G Manual De Instrucciones página 24

23 | English
OPERATION SAFELY
- Before starting the machine, look into the feeding
chamber to make certain that it is empty.
- Keep your face and body away from the hopper.
- Do not allow hands or any other part of the body or
clothing inside the feeding chamber, discharge
chute, or near any moving part.
- Keep a proper balance and footing at any time.
Do not overreach. Never stand at a higher level
than the base of the machine when feeding
material into it.
- Be extremely careful that pieces of metal, rocks,
bottles, cans or other foreign objects are not
included. If the cutting mechanism strikes any
foreign objects or if the machine should start
making any unusual noise or vibration, shut off the
power source and allow the machine to stop.
Disconnect the spark plug wire from the spark plug
(electric unit disconnect from supply).
- Inspect for damage. Check for and tighten any
loose parts. Have any damaged parts replaced or
repaired with parts having equivalent
specifi cations.
- Do not allow processed material to build up in the
discharge zone; this may prevent proper discharge
and can result in kickback of material through the
feed intake opening. If the machine becomes
clogged, shut- off the power source and disconnect
the spark plug wire (electric unit disconnect for
supply) before clearing debris. Keep the power
source clear of debris and other accumulations
to prevent damage to the power source or possible
fi re. Remember that operating the starting
mechanism on engine powered machines will still
cause the cutting means to move. Keep all guards
and defl ectors in place and in good working
condition.
- Do not tamper with the power source governor
settings; the governor controls the safe maximum
operating speed and protects the power source
and all movingparts from damage caused by
over-speed. Seek an authorised Garland service if
a problem exists.
- Do not transport this machine while the power
source is running. Shut off the power source and
disconnect the spark plug lead (electric unit
disconnect from supply) whenever you leave the
work area. Do not tilt the machine while the power
source is running.
ASSEMBLY INSTRUCTIONS
Unpacking the components. If something is missing,
please contact your sales shop. The assembly has to
be done in a clean, tidy and balanced area. You will
need help to do it properly.
1. Wheel installation.
Lift the machine a little, and reeve the wheel with the
wheel shaft. Fix the nuts in a safety way.
2. Discharge chute installation.
Shaft