Össur TOTAL KNEE 2100 Instrucciones Para El Uso página 11

COSMETIC OPTIONS (Figure 11 & 12)
We recommend a discontinuous cosmetic solution which does not
interfere with knee function. Continuous cosmetic solutions are also
possible.
Discontinuous Cosmetics
Ref. No Description
2145 Shin ferrule
2150 Knee cap - small
2151 Knee cap - large
Foam cover - large,
2175L
high activity
MAINTENANCE
The Total Knee 2100 is designed for low-maintenance. It is warranted
against defective materials and workmanship for 24-months. We
recommend:
• Total Knee 2100 be inspected every six months for signs of unusual
wear, by a prosthetist familiar with this product.
• Stance flexion bumper must be replaced if cracked or worn,
depending on patient´s activity level.
• If knee is subjected to excessive moisture or corrosive environment,
it's recommended to clean and lubricate the knee frequently.
CLEANING
• Wipe knee with soft cloth moistened with small amount of kerosene.
DO NOT use solvent stronger than kerosene. If kerosene is not
available, use general purpose oil (3in1) or sewing machine oil.
• DO NOT dip knee or pour solvent over knee. Bearings and seals may
be damaged.
• DO NOT use compressed air to clean knee. Air forces pollutants into
bearings and may cause malfunctions and wear.
LUBRICATION (Figure 13)
There are 6 lubrication points on the knee, three on each side. One shot
of grease at each lube point is all that is required every 4-6 months. Use
only Össur grease gun, part #2105, and the grease supported with the
grease gun.
PRODUCT-SPECIFIC TRAINING
Instructing new users is essential to achieve a successful rehabilitation.
For safety, initial adjustments and gait training should be done with
patient standing between parallel bars.
LEVEL GROUND WALKING
• Explain to the user the function of stance flexion/geometric lock.
Patients who previously wore a knee without stance flexion function
may fear collapse of knee during loading response. They must be
trained to allow the knee to move into stance flexion and not to
prevent it by strong hip extension
• Explain the stance release mechanism to the patient. Patient's centre
of mass must be anterior to the pivot axis of knee. In this position,
very little hip flexor effort is required to initiate knee flexion. Knee
Notes
Protects unit from foam cover - maintains
space for movement within foam cover
Use to prevent tearing at the knee
Use for patients who kneel often
Accommodates shin ferrule
11